Flash Drying Oven is designed to dry calcium alloyed plates. After pasting pasted panels, pass through FDO (Flash Drying Oven). The FDO is used for drying plates /panels and to attain the desired moisture, which is an important factor for curing process. The moisture content ideally should be 8~11%.

Plates are carried by steel conveyor. The speed of the horizontal conveyor can be continuously varied as to match the output of the pasting machine. The oven has inspection doors all around the main frame for easy maintenance.

• 40 – 220 panels per minute capacity
• Electrically Heated/gas fired
• Convection/Direct/Indirect/Infrared Heating System
• Fully automatic control panel with VFD, Thyristor
• Honey comb Chain SS 316 L
• Less energy consumption (30%), resulting in lower monthly utility bill
• Six access doors for maintenance
• Vertical sliding door –   Design   accordingly human safety Space saving door to simplify loading
• Radiation technology –  moisture control from surface of the plates
• Touch screen HMI, PLC for parameter feeding and annunciation
• Various temperature ranges to suit your application.
• High efficient heat transfer and energy utilization.
• Thermal loss is prevented by filling rock wool (Insulation) in space between the outer body & Inner chamber.

The purpose is to cure a coating, adhesive or a product. To have a successful curing process, the size of the heat source and distribution of airflow need to be considered. In-depth knowledge of Curing Process. We are just not manufacturing ovens; we are continuously working on improving curing process.

We are doing a lot of development for improving curing process for increasing quality, efficiency and reducing operating cost. Since we have worked in this area for last 18 years we have experience and knowledge of areas to be worked in these ovens like heaters, spray nozzles. And based on that we have found solutions and incorporated them into our oven.

• Our Curing Chamber consists of multistage curing cycle.
• In each step different humidity, temperature and air flow settings can be set and achieved.
• We offer chamber with both humidification cycle and drying cycle can be done.

• Custom sizes to meet your specific process requirements are available.
• Heavy gauge, cold rolled reinforced steel exterior and door
• Touch screen HMI, PLC for parameter feeding and annunciation
• Various temperature ranges to suit your application.
• Data communication system.
• VFD for fine control of air flow.
• Very effective for high production rate.
• Cure in uniform rate.
• High efficient heat transfer and energy utilization.
• Thermal loss is prevented by filling rock wool (Insulation) in space between the outer body & Inner chamber.
• High thermal efficiency